ZitatAlles anzeigenOriginal von Bauforum24.biz
Also ich hab schon mehrfach Softreset gemacht und alle Programme im Speicher rausgeschmissen so das nur MN4 lief. Trotzdem kein Erfolg.
Anbei mal meine spgps.ini:
[SerialPort]
Port=2
Baud Rate=4800
Parity=N
StopBits=1
DTR flow control type=enable
RTS flow control=enable
Binary mode, no EOF check=0
Enable parity checking=0
CTS output flow control=0
DSR output flow control=0
DSR sensitivity=0
XOFF continues Tx=0
XON/XOFF out flow control=0
XON/XOFF in flow control=0
Enable error replacement=0
Enable null stripping=0
Abort reads/writes on error=0
Transmit XON threshold=0
Transmit XOFF threshold=0
Byte size=8
Tx and Rx XON character=0
Tx and Rx XOFF character=0
Error replacement character=0
End of input character=0
Received event character=0
Irgendwas auffälliges daran zu finden?
Da fehlt wohl was - die Grösse 6xx KB ist auch zu wenig; zumindest bei den Konfigurationen, die ich kenne.
Nimm mal die Dir angebotene und setze sie nach dem Kopieren gleich auf "schreibgeschützt". Allerdings könnte es sein, daß "Port 2" nicht passt, aber das weiß ich nicht.