Yakumo 300 WAAS/EGNOS fähig?

  • Hallo, Frage wie schon im Betreff. Beherrscht der Yakumo 300 GPS auch diese Möglichkeit zur Präzisionsverbesserung?

    Einmal editiert, zuletzt von Antichrist ()

  • Hallo zusammen,


    bin zwar kein grosser Experte, versuch mich aber trotzdem mal an einer Antwort.


    Der Yakumo besitzt einen Sirf II Chip und dieser sollte schon in der Lage sein, die Korrektursignale zu empfangen.


    Das Problem liegt auf der Software-Seite, diese muss die Signale auch auswerten (können).


    Nur, welche macht das ??


    Gruss Farron

  • @Farron Danke, endlich mal eine Antwort.


    Also du meinst es liegt nur an der Software, das wäre ja super.


    Vom Yakumo Support habe ich diese Antwort erhalten:
    "Das Gerät unterstützt ausschließlich das herkömmliche GPS."
    Allerdings weiß man ja nie wie gut einer von der Hotline die eigenen Produkte kennt.


    Noch habe ich den Yakumo nicht, die meißtens Shops haben ja recht lange Lieferzeiten, darum habe ich noch nicht bestellt.
    Ein alternatives Bundle zu dem Preis scheint es ja nicht zu geben.

  • Hallo,


    da wäre ich jetzt nicht so sicher. Die Angaben zum GPS-Teil des Yakomo sind leider mehr als mager.


    Wenn ich dann vergleiche, dass bei dem Maustool das bei der Emtac-BT dabei war - CruxView - die Egnos-Funktion (SBAS) programmiert werden kann, muß ich zu dem Eindruch gelangen, dass das beim Yakumo nicht möglich ist. Außerdem werden die Egnos-Signale m.W. immer noch nur im Testbetrieb gesendet und der bei uns empfangbare Sat steht so tief am Horizont, dass er nur slten empfangen werden kann.


    Im übrigen kann das im NMEA-Protokoll (log) in der GGA-Zeile überprüft werden:


    $GPGGA,102049.110,4801.3988,N,00752.0997,E,1,03,8.4,315.0,M,,M,1.7,0000*64
    GGA = Global Positioning System Fix Data
    102049.110 = Fix taken at 10:20:49 UTC
    4801.3988,N = Latitude 48° 01,3988 min North
    00752.0997,E = Longitude 7° 52,0998 min East
    1 = Fix quality: 0 = invalid
    1 = GPS fix
    2 = DGPS fix, aktiviert auch bei EGNOS


    (die Erklärungen sind nicht komplett, sonst siehe hier
    unter FirstStep.

  • Ich hab (wissen vielleicht noch nicht alle) den YakumoGPS (world best, with GPS antenna integrated), das tut mich theoretisch (!) auch sehr interessieren, praktisch aber ned, weil ich will eh keine Cruisse Missile auf mich abschiessen. Da kommts auf ein paar Meter links oder rechts nicht an.


    Aus der Beschreibung ...


    The SiRF chipset in the Yakumo GPS is capable of supporting WAAS, however Mitac is still in the process of implementing WAAS support on this Pocket PC. The receiver's sensitivity seems to be tuned very well and gave very accurate readings for locations in our tests even without the WAAS support.


    Was zum Teifi ist WAAS?


    Why is a GPS receiver that utilizes WAAS better than the others?
    With more and more GPS receivers coming out with WAAS, it might help to understand what WAAS is and how it works better for your GPS. WAAS stands for Wide Area Augmentation System. The FAA states that WAAS is based on a network of approximately 25 ground reference stations that covers a very large service area. Each of these precisely surveyed reference stations receive GPS signals and determine if any errors exist. Each wide area ground reference station in the network relays the data to the wide area master station (WMS) where correction information is computed. The WMS calculates correction algorithms and assesses the integrity of the system. A correction message is prepared and uplinked to a geosynchronous satellite via a ground uplink system (GUS). The message is then broadcast from the satellite on the same frequency as GPS (L1, 1575.42MHz) to GPS receivers, which are within the broadcast coverage area of the WAAS.


    In a simpler term, WAAS-capable GPS receivers give you better position accuracy by correcting signal errors caused by ionospheric disturbances, satellite orbit errors and other spatial or technical data degradation factors. These GPS receivers will use some of their channels to track WAAS satellites and use WAAS satellite in their position solution. Here is a data accuracy chart published by Garmin:


    100 meters: Accuracy of the original GPS system, which was subject to accuracy degradation under the government-imposed Selective Availability (SA) program.
    15 meters: Typical GPS position accuracy without SA.
    3-5 meters: Typical differential GPS (DGPS) position accuracy.
    < 3 meters: Typical WAAS position accuracy.


    At the present time, there are two geo-stationary satellites serving the WAAS area, which is only in North American. One covers the Pacific Ocean Region (POR), the other covers the Atlantic Ocean Region-West (AOR-W). (If you wish to see a map of WAAS coverage, follow this link.) Europe and Asia will eventually be served by EGNOS and MSAS. Hopefully soon, everyone on earth will have access to precise position data using SBAS (Satellite Based Augmentation System).



    [Blockierte Grafik: http://www.pocketgps.co.uk/menus/reviews/hardware/rikalinex5.jpg]


    The Rikaline 6010 X5 GPS receiver is available in a number of configurations and is built on a modular cabling system, more of which later.


    As with a lot of modern GPS devices it uses the SiRF star II chipset, which boasts high sensitivity and better fixes in "Urban Canyons".


    The receiver also comes with SBAS (WAAS/EGNOS) for additional positional accuracy.


    [Blockierte Grafik: http://www.pocketgps.co.uk/menus/reviews/hardware/fortunau2.jpg]



    The Fortuna U2's base of the receiver is magnetic, to stop the mouse escaping when taking sharp corners.


    The receiver also comes with SBAS (WAAS/EGNOS) for additional positional accuracy and a variety of cable connections are available.

    3 Mal editiert, zuletzt von etckarwalas ()