Hi!
Versuche schon Tagelang auf meinem Compact Ozi zum laufen zu bringen. Meine Wonde-x will nicht... welche einstellungen bezüglich port (com) muß ich vornehmen? bei com4 + com5 sucht das programm etwas lännger und gibt dann "no Data received from the GPS" aus. Dann hängt sich der MDAc auf...
Bei den anderen Ports sagt er sowieso das er nicht verbinden kann.
Hat jemand erfahrung damit?
Bitte helft mir, bin am verzweifeln...
Lg, Pam.
Hi!
hat sich erledigt. Falls noch wer das Prob. hat siehe hier!
Auf der OZI Seite ist das prob behandelt. Allerdings für MDA II aber ist das selbe Problem.
Danke!
Hier das Tool:
http://216.218.220.254/ozice/support/BTHTools1100.zip
Hier die Beschreibung:
Zitat OZI Homepage:
Bluetooth Tools:
If you are using a O2 XDA II or MDA II or Qtek 2020 or any other PDA's based on the same hardware with a bluetooth gps then you will not be able to connect to the gps with OziExplorerCE, you will get ERR in the top right corner above the map. This is not a problem with OziExplorerCE it is a well known problem with these devices, their bluetooth implementation does not work properly and requires a patch.
There are some programs which do work with these devices without the patch but these are most likely using simple polling of the serial port. I can also read the serial port using polling but this is not a suitable method to use as it slows the software down considerably, an event driven reading method must be used and this is where the patch is required.
Setup for the Bluetooth Tools
If you have any paired devices delete them.
Download and install the Bluetooth Tools to the PDA.
Reset the PDA.
Run the bluetooth manager.
Using the bluetooth manager search for the gps
When found highlight it in the list and click on Next
Enter the Device PIN: (should be in the gps manual, if not try 0000);
Click Next
Click Finish
When asked if you want to create a Bluetooth serial port answer Yes.
The serial port number that will be used is shown (remember the number, you will need it to configure OziExplorerCE) Tick the Serial port box
Press the (ok) button on the top right of the screen to close the bluetooth manager (need to press 2 times)
Reset the PDA (this is important, if you do not do this the new serial port will not be created)
Run OziExplorerCE and in NMEA (GPS) configuration set the Serial Port Number created by the Bluetooth Tools as the Communication Port.
