Sorry, I have do this in English, my German is not very good. 
I have a MD95083. Everything workes well, but when I select an item with the stylus, I do not hear the "clicking" sound when you select something.
Does anyone know how to enable this?
I tried a soft and hard reset already. No result...
thx
Try the following steps:
Push the noise-calibrator and in the same time, u need to do a soft reset. in case it was really helpfull and started to work.
Sorry, no result 
I tried: the sound key selecting louder, keeping this key selected and pressed softreset
During rebooting I kept the sound selector in it's position.
I also tried: to press (so no sound harder or softer) the sound selector and pressed softreset, during rebooting I kept the sound selector pressed.
I also tried to release the sound selector button during reboot, but no result...
Any other suggestions?
thx
put in the headphones and listen. is any sound there? if answer ist yes, try this:
- put in headphones and make a soft reset
- - " - and switch it louder and make a soft reset
- - " - , switch it louder and while u make a soft reset, take of the headphones
try everything like that. i had the same prob but after some tries like that it worked 
the voices for directions are no problem, I can hear them, only the "clicking" sound not...
aarchhhh 
@oscar1001:
> I have a MD95083. Everything workes well, but
> when I select an item with the stylus, I do not hear the "clicking" sound when you select something.
> Does anyone know how to enable this?
The Windows CE Control Panel allows you to set a
variety of system-wide properties.
You have to use the Control Panel application "Sound"
to change the settings of volume and sound.
Good luck!
I tried this panel also, but no result. I guess I have to live with this...
Any suggestions are welcome.
